⚠ Unprotected Your provider sees every site you open. Encrypt it →
Setup

Connected in a minute,
on any device.

You get one subscription link. Any WireGuard-compatible app can take it - pick your platform below.

  1. Install an app. WireGuard for normal networks, or Happ / AmneziaVPN if your country filters VPNs.
  2. Open your cabinet and copy the subscription link, or keep the QR on screen.
  3. Add the tunnel. In WireGuard tap + → Create from QR code and scan. In Happ tap + → Add from clipboard.
  4. Allow the VPN profile when iOS asks - this is the system permission every VPN needs.
  5. Toggle it on and reload the leak check: the IP should now be the server's.
On iOS, turn on On-Demand in the tunnel settings so the connection comes back by itself after a reboot or a network switch.
  1. Install WireGuard, or Happ / AmneziaVPN for filtered networks.
  2. Copy the subscription link from your cabinet.
  3. Import it: WireGuard → + → Scan from QR code; Happ → + → From clipboard.
  4. Accept the VPN request from Android.
  5. Connect, then confirm on the leak check.
Enable Always-on VPN and Block connections without VPN in Android network settings - that's a kill switch at the system level.
  1. Install the WireGuard client for Windows (or AmneziaVPN on filtered networks).
  2. Download the .conf from your cabinet.
  3. Add the tunnel: Add Tunnel → Import from file, then pick the file.
  4. Activate and check the status turns green.
  5. Verify on the leak check.
WireGuard for Windows routes everything through the tunnel when AllowedIPs is 0.0.0.0/0, ::/0 - our configs already are, which also closes IPv6 leaks.
  1. Install WireGuard from the App Store, or AmneziaVPN.
  2. Download the .conf from your cabinet, or copy the subscription link.
  3. Import: Import tunnel(s) from file, or add from the clipboard.
  4. Allow the configuration in System Settings when prompted.
  5. Connect and confirm on the leak check.
Tick On-Demand so macOS reconnects automatically on wake and on new Wi-Fi networks.
  1. Check the firmware. WireGuard is built into OpenWrt, OPNsense, GL.iNet and recent AsusWRT.
  2. Open the VPN / WireGuard section and create a client tunnel.
  3. Paste the config from your .conf file - interface keys, then the peer block.
  4. Set DNS to the address in the config so lookups stay inside the tunnel.
  5. Apply, then check any device on that network with the leak check.
A router tunnel covers everything on the network - TVs, consoles, anything without a VPN app. It counts as one device against your plan.

Which app should I use?

WireGuard

The official client. Fastest and simplest - use it wherever VPNs aren't filtered.

AmneziaVPN / Happ

Speak AmneziaWG, which disguises the traffic. Use these where plain VPN protocols get blocked.

Streisand / v2rayTun

Multi-protocol clients. Handy if you juggle several providers on one device.

No key yet?

Generate one now - no email, no signup form.

Get my VPN →